HPA Regulator Removers
Aluminum AND 3d Printed
Regulator Removal tools designed for almost every regulator that does not have a built in removal option like the Crossfire tanks.
Powerhouse Reg. Removal Tool
Anodized Engraved Aluminum
These are designed around the Powerhouse regulators. These have a wider inside diameter than the ninja removers and the legs on the bottom are thinner and weaker due to it.
​
Designed with a hex cut for 1" sockets, a 3/8" through hole for a pry bar or long screw driver, or for use in a vise with a strap wrench as intended and just makes life easy. Made from 6061 Aluminum, manually cut, anodized, and laser engraved by me. I put a lot of work into each one of these and I do my best to keep the price down and still bring you a top quality tool. I try my best to give everyone their choice of color, pattern, and finish for anodizing. I also engrave each tool with an easy ID logo and my BMC logo on an 100 watt CO2 laser engraver.
I DO NOT recommend using this remover on any other style of regulators beyond these. They are not really designed to hold up to Loctite as that is not recommended on the regulators as it is.
Ninja / Immortal Air / Universal Reg. Removal Tool
Anodized Engraved Aluminum
These are designed around the Ninja regulators and also fit the Immortal Air, Pure Energy, Gorilla/Myth, and other similar style regulators. These are my original removers that have been refined over a few years and seem to hold up well to Loctite.
​
Designed with a hex cut for 1" sockets, a 3/8" through hole for a pry bar or long screw driver, or for use in a vise with a strap wrench as intended and just makes life easy. Made from 6061 Aluminum, manually cut, anodized, and laser engraved by me. I put a lot of work into each one of these and I do my best to keep the price down and still bring you a top quality tool. I try my best to give everyone their choice of color, pattern, and finish for anodizing. I also engrave each tool with an easy ID logo and my BMC logo on an 100 watt CO2 laser engraver.
​
I have had reported stories of cross threaded regs that broke/snapped off at the stem before the remover took much damage, I can confirm one of those removers are still taking regs off on a weekly basis.
​
3D Printed Regulator Removers
Designed and Printed by BMC Fabrication
3D printed blocks designed to fit their respective regulators. Printed with high infill and flexible TPU material to protect your regulators from tool and vise marks but strong enough to help remove regulators. They are not really designed to break Loctite or cross threaded regulators.
​
Send me an email and let me know if you would like another style designed. Always looking to add to the collection.
5703 Ridge Ct.
Springfield, Oregon 97478
©2020 by BMC Fabrication. Proudly created with Wix.com